Read the Beforeitsnews.com story here. Advertise at Before It's News here.
Profile image
Story Views
Now:
Last hour:
Last 24 hours:
Total:

BBQ Chicken Sliders: Ready in 30 Minutes

% of readers think this story is Fact. Add your two cents.


Sliders are fun to eat, especially when sweet, sticky barbecue sauce is in play. These BBQ chicken sliders are a super party favor and easy to prepare in all four seasons.

Read on for the details on what to expect and ingredients, plus tips to ensure people will keep raving about your chicken sliders long after they’re looking the sauce off their fingers. Full instructions are in the recipe card below.

BBQ chicken sliders: What to expect

  • Taste: Barbecue sauce takes the reins here. Cool, herby ranch adds zing.
  • Texture: With grilled chicken, toasted slider buns, and some romaine lettuce, this dish starts with a crunch and ends with the satisfying softness of shredded chicken.
  • Foolproof factor: BBQ chicken sliders are foolproof if you have a meat thermometer for the chicken. See the tips section below if you don’t have a meat thermometer.
  • Timing: If you’re efficient in the kitchen, you can have these ready in about 30 minutes or less.  

Slider ingredients and how to use them

Ingredients for BBQ chicken sliders on a cutting board.
©Blog Chef.

You need a total of seven ingredients for BBQ chicken sliders. Even better, you may have most of these ingredients on hand already.

  • Boneless, skinless chicken breast: Two large boneless, skinless chicken breasts should provide you with roughly 2 lb. of meat.You don’t have to be exact here. Sliders are forgiving — stuff them tall if you have a lot of chicken or make low-profile sliders if you have less chicken.
  • BBQ sauce: One-half cup of BBQ sauce does the trick. Choose whatever flavor you like in large doses. Spicey or sweet works.
  • Sliced provolone cheese: Normal cheese slices are made for sandwiches, not sliders. I like the cheese to fit nicely within the small bun, so I will carve a smaller circle out from an average cheese slice. You could also cut a cheese slice into quarters and place two quarters on each slider. Mozzarella also works for this recipe if you don’t want provolone.
  • Slider buns: You should get eight to 10 slider portions from this recipe, so buy a 12-pack of buns.
  • Butter: Butter coats the buns before you toast them. You could skip this step and omit the butter entirely or you could substitute olive oil instead.
  • Ranch dressing: Bottled ranch or homemade works equally well.
  • Lettuce: One leaf of romaine lettuce torn into pieces will do the trick. You could also use iceberg or green leaf. Or, if you don’t like cold ingredients on a hot sandwich, skip the lettuce.  

Equipment needed for BBQ chicken sliders

You will need a BBQ or a stovetop grill pan to cook the chicken, plus two forks to shred the chicken. A meat thermometer is also useful, but not necessary.

Tips for success

Partially made BBQ chicken sliders on white plate.
You can stack these sliders tall if you have lots of chicken or go low-profile if the chicken supply is tight. ©Blog Chef.

The only point of possible failure in this recipe is cooking the chicken for too long or not long enough. A meat thermometer is the simplest solution. It’ll tell you when the thickest part of your breast reaches a safe temperature of 165°F or 74°C.

If you don’t have a meat thermometer, you can:

  • Cook the chicken breast for 9 minutes per side, let it rest of three minutes, then check for doneness.
  • Pound the chicken so it’s an even thickness. A thinner piece will cook faster, probably in 6 or 7 minutes per side. To pound chicken, place it between two pieces of wax paper, parchment paper, or plastic wrap. Then start pounding with a mallet or something else solid (like a rolling pin).
  • Cut the chicken into strips first and then cook it. You can then cut open a strip to ensure doneness without losing all the juices from an entire breast.  

More party recipes

Sliders are a mainstay on Super Bowl party menus. Round out your party menu with these favorite party dishes:

Prepared BBQ chicken sliders on white plate.
©Blog Chef.

Print

Prepared BBQ chicken sliders on white plate.
BBQ Chicken Sliders

Sliders are fun to eat, especially when sweet, sticky barbecue sauce is in play. These BBQ chicken sliders are a super party favor that are easy to prepare in all four seasons.

  • Total Time: 26 minutes
  • Yield: 4 servings
Ingredients
Units

  • 2 lb. boneless skinless chicken breasts
  • 1/2 cup BBQ sauce
  • 810 slider buns
  • Butter
  • 810 small slices of provolone or mozzarella cheese
  • 1/3 cup ranch dressing
  • 1 large leaf of Romaine or iceberg lettuce, torn into small pieces

Instructions
  1. Set out a stick of butter to soften.
  2. Grill chicken on an outdoor grill or a grill pan inside. For outdoor grill, grease your grill plates and preheat the grill to medium-high. If using a grill pan, add a small bit of oil to the pan and turn on the flame to medium-high. Place chicken on heated grill or pan and let it cook for 7 minutes. Flip and cook another 7 minutes. Check the temperature with a meat thermometer. The chicken is done with the temperature at the thickest part is 165°F or 74°C. Remove it from the heat and let it rest for 3 minutes.
  3. Shred the chicken with two forks. Place it in a bowl, add the barbecue sauce, and mix until the chicken is well-coated.
  4. Split the sliders buns in half, and butter each half. Place butter side down on the grill or in a frying pan and cook until browned.
  5. Spread ranch dressing on the inside of the top halves of the buns. Pile shredded BBQ chicken on the bottom half. Top with a slice of cheese, then lettuce. Place the top half of the bun on top.
  • Author: Blog Chef
  • Prep Time: 10 minutes
  • Additional Time: 0 hours
  • Cook Time: 16 minutes
  • Category: Appetizers
  • Cuisine: BBQ
Nutrition
  • Serving Size: 1
  • Calories: 840
  • Sugar: 20
  • Sodium: 1258
  • Fat: 27
  • Saturated Fat: 8
  • Unsaturated Fat: 16
  • Trans Fat: 0
  • Carbohydrates: 60
  • Fiber: 5
  • Protein: 85
  • Cholesterol: 216
Did you make this recipe?

Share a photo and tag @thisisblogchef — we can’t wait to see what you’ve made!


Source: https://blogchef.net/bbq-chicken-sliders-recipe/


Before It’s News® is a community of individuals who report on what’s going on around them, from all around the world.

Anyone can join.
Anyone can contribute.
Anyone can become informed about their world.

"United We Stand" Click Here To Create Your Personal Citizen Journalist Account Today, Be Sure To Invite Your Friends.

Humic & Fulvic Liquid Trace Mineral Complex

HerbAnomic’s Humic and Fulvic Liquid Trace Mineral Complex is a revolutionary New Humic and Fulvic Acid Complex designed to support your body at the cellular level. Our product has been thoroughly tested by an ISO/IEC Certified Lab for toxins and Heavy metals as well as for trace mineral content. We KNOW we have NO lead, arsenic, mercury, aluminum etc. in our Formula. This Humic & Fulvic Liquid Trace Mineral complex has high trace levels of naturally occurring Humic and Fulvic Acids as well as high trace levels of Zinc, Iron, Magnesium, Molybdenum, Potassium and more. There is a wide range of up to 70 trace minerals which occur naturally in our Complex at varying levels. We Choose to list the 8 substances which occur in higher trace levels on our supplement panel. We don’t claim a high number of minerals as other Humic and Fulvic Supplements do and leave you to guess which elements you’ll be getting. Order Your Humic Fulvic for Your Family by Clicking on this Link , or the Banner Below.



Our Formula is an exceptional value compared to other Humic Fulvic Minerals because...


It’s OXYGENATED

It Always Tests at 9.5+ pH

Preservative and Chemical Free

Allergen Free

Comes From a Pure, Unpolluted, Organic Source

Is an Excellent Source for Trace Minerals

Is From Whole, Prehisoric Plant Based Origin Material With Ionic Minerals and Constituents

Highly Conductive/Full of Extra Electrons

Is a Full Spectrum Complex


Our Humic and Fulvic Liquid Trace Mineral Complex has Minerals, Amino Acids, Poly Electrolytes, Phytochemicals, Polyphenols, Bioflavonoids and Trace Vitamins included with the Humic and Fulvic Acid. Our Source material is high in these constituents, where other manufacturers use inferior materials.


Try Our Humic and Fulvic Liquid Trace Mineral Complex today. Order Yours Today by Following This Link.

Report abuse

    Comments

    Your Comments
    Question   Razz  Sad   Evil  Exclaim  Smile  Redface  Biggrin  Surprised  Eek   Confused   Cool  LOL   Mad   Twisted  Rolleyes   Wink  Idea  Arrow  Neutral  Cry   Mr. Green

    MOST RECENT
    Load more ...

    SignUp

    Login

    Newsletter

    Email this story
    Email this story

    If you really want to ban this commenter, please write down the reason:

    If you really want to disable all recommended stories, click on OK button. After that, you will be redirect to your options page.